- Aluminum water bottles for dye sublimation
- Two lid options (pop-top or screw top) with carabiner
- Capacity: 20oz. (600ml)
- Available in two colors: white and natural silver
- For use with a Mug Press or Water Bottle Wrap
-
Mug Master Pro Mug Press
Idle Temperature: 275°F
Press Temperature: 330°F
Time: 15 Seconds
Pressure: Medium
- Tape the sublimation paper with image printed in reverse to the water bottle with thermal tape
- When the heat press reaches the idle temperature, you will hear a beeping sound indicating that the machine is ready
- Place the water bottle in the element and close it by pulling the handle towards you
- Press the green, round button to begin the pressing cycle (temperatures may drop which is normal)
- Once the press temperature is reached, the timer will begin counting down
- When the timer reaches 0, take out the water bottle from the press and remove the transfer paper immediately
- Allow the water bottle to cool completely before use
GeoKnight DK3
Press Temperature:- 400°F
Time:- 3 Minutes
Pressure:- Medium
- Attach sublimation transfer paper with image printed in reverse to the water bottle with thermal tape
- Place water bottle in heat press at the press temperature, and close the element around the water bottle
- Press for the specified time above needed using specified pressure
- If the image begins to look blurry, or burnt brown by over-pressing, decrease pressing time by 15 - 30 seconds
- Once done, remove the water bottle from the press and remove the transfer paper immediately
- Allow the water bottle to cool completely before use
4-in-1 Mug Press
Press Temperature:- 320°F
Time:- 150 - 180 Seconds
Pressure:- Medium/Firm
- Attach sublimation transfer paper with image printed in reverse to the bottle with thermal tape
- Place bottle in press at the press temperature, and close the element around the bottle
- Press for the specified time above needed using specified pressure
- If the image begins to look blurry, or burnt brown by over-pressing, decrease time by 15 - 30 seconds
- Once done, remove the bottle from the press and remove the transfer paper immediately
- Allow the water bottle to cool completely before use
Oven Settings
Press Temperature:- 400°F
Time:- 6 - 10 Minutes
(test in your oven for accurate time)
- Attach reversed printed image to water bottle with thermal tape
- Wrap silicone wrap around water bottle surface and clasp at handle
- Place in oven preheated to 400°F for approximately 6 - 10 minutes (test to determine best timing!)
- Afterwards, remove wrap and transfer immediately
- Allow the water bottle to cool completely before use